To build your Customer Hardware Solution – Small Edge device, you need to work with your preferred hardware vendor to acquire the HPE hardware components identified in the table. Each row in the table lists a hardware item, a recommended HPE product number, and, in case the recommended HPE product is unavailable, approved HPE alternative product numbers. If no approved alternative exists, the alternative is marked as N/A.

If you need more information on components or want to verify the components that you have purchased, see the HPE PartSurfer and search for the Product number. (On HPE PartSurfer, product numbers and part numbers may be different.)

Note: The Customer Hardware Solution – Small requires three (3) internal hard drives. The BYOC Premises – Customer Hardware Solution installer sets up two of the hard drives in a RAID 1 configuration and then sets up the third hard drive for support purposes. More specifically, the third drive stores local media used for factory image restoration and provides space for over-the-air operating system upgrades.
Hardware component Recommended HPE product number  Alternative HPE products
HPE ProLiant MicroServer Gen10 Plus V2 Chassis P54654-001 Any HPE ProLiant MicroServer Gen10 Plus V2 Chassis with Xeon E-2314 CPU and 16GB of memory
Two – Hard Drives 801882-B21 Any HPE approved SSD or HDD 960GB or larger.
iLO Enablement Kit P13788-B21 N/A

† – Optional

‡ – Argentina Only

* – Requires three hard drives

After you have acquired your Customer Hardware Solution hardware and have it assembled, you are ready to set up your Edge. For more information, see Set up a Customer Hardware Solution Edge.

Date Revision
December 11, 2023

Updated the bill of materials with newly validated next generation hardware components.

September 28, 2023

Added Alternative HPE product number section to Next generation bill of materials – Small

August 31, 2023

Added BOM for next generation hardware and coming soon flag.

February 1, 2023

Reorganized Table to more clearly display bill of materials.

April 20, 2022

Identified both Required and Optional items in the bill of materials. 

March 23, 2022
  • Added details about the third hard drive requirement
  • Added an alternative bill of materials based on the P16006 chassis
March 2, 2022 Added a second hard drive to the bill of materials. 
February 16, 2022 Published the Bill of materials for the Customer Hardware Solution – Small article in the Resource Center.